CORNER
GUARDS
|
|
|
|
|
Installation Instructions
1. Determine (measure) actual length of corner guard required. 2. Corner guard may be cut to desired length with a sharp utility knife or scissors. 3. Remove both strips of release paper from self-stick material on back side of corner guard (use care not to touch adhesive material). 4. Position corner guard on selected wall location and press firmly to ensure adhesion to wall surface. 5. It is recommended to roll both sides of corner guard over its entire length with a small wooden roller, such as a wallpaper seam roller, or rub with clean, dry cloth to ensure good adhesion.
Care & Maintenance Wash the surface with a neutral pH detergent and warm water solution. |
|
||
|
Copyright
© Safe-T-First 2000. All rights reserved. |
utility knife
