GUIDANCE
STRIPS
|
|
|
|
|
Installation Instructions
1. Make certain that the surface on which the guidance strips are to be installed is clean, dry and free of dust, dirt, grease, loose or peeling paint or wallpaper, etc. 2. Remove protective paper from adhesive strip on back of guidance strip and position it carefully without actually touching the wall surface. 3. CAUTION: Adhesive sticks on contact. DO NOT touch the back surface of the guidance strip to wall surface until guidance strip has been correctly positioned. Once guidance strip touches wall surface, repositioning guidance strip will NOT be possible. 4. After guidance strip has been correctly positioned, press it firmly in place by rubbing entire surface with clean, dry cloth or wallpaper seam roller to ensure uniform contact of adhesive to wall surface. 5. To cut guidance strip to shorter length, measure accurately and cut, using sharp utility knife or scissors. \ Care & Maintenance Wash the surface with a neutral pH detergent and warm water solution, as required. If high traffic conditions exist or to expedite cleaning, wash thoroughly and then apply one or two coats of a liquid, acrylic floor finish. |
|
||
|
Copyright
© Safe-T-First 2000. All rights reserved. |
utility knife or scissors