Untitled Document


RUBBER WALL BASE

Installation Instructions:

Tools Required:

utility knife or scissors
tape measure
clean, dry cloth
wallpaper seam roller (optional)

1. Make certain that the area of wall surface on which wall base is to be installed is clean, dry, and free of dust, dirt, grease, loose or peeling paint or wallpaper, etc.

2. Remove protective paper from adhesive strip on back of wall base and position it carefully without actually touching the wall surface.

3. CAUTION: adhesive sticks on contact. DO NOT touch the back surface of wall base to wall surface until wall base has been correctly positioned. Once wall base touches the wall, repositioning of wall base will NOT be possible.

4. After wall base has been correctly positioned, press it firmly in place by rubbing entire surface with clean, dry cloth or wallpaper seam roller to ensure uniform contact of adhesive to wall surface.

5. To cut wall base to shorter length, measure accurately and cut using a sharp utility knife or scissors.

Care & maintenance:

Wash the surface with a neutral pH detergent and warm water solution. A liquid, acrylic floor finish may be applied, if desired, to ease maintenance.

<<Main Care & Installation Page